Fitting Instructions

Welcome to the Flush and Save water saving device Fitting Instruction page.

STEP 1

Remove the toilet pan, this can be done by a competent DIY enthusiast or by your local plumber. Further information on how do this is widely available on the internet

STEP 2

Remove the toilet pan connector from the back of your toilet, (the toilet pan connector is approximately 4in. in diameter, white in colour with a black rubber sealing ring)

STEP 3

Remove the black rubber sealing ring from the existing pan connector or your new pan connector.

STEP 4

Remove the Flush & Save valve from its packaging and push it onto the pan connector. On the lid of the valve you will find the word ‘top’ this is to be fitted to the pan connector so the lid opens in an upwards fashion to allow full discharge when the toilet is flushed. Always ensure the lid opens upwards when using a horizontal pan connecter.

STEP 5

When fitting to a vertical pan connector ensure the lid will open working with the flow of any bends.

STEP 6

Re fit the toilet as you would normally, the Flush & Save water saving valve will seal all pipes just like a standard non protected pan connector.

STEP 7

The final step is to adjust the amount of water your toilet uses each time it flushes. This is quite a straightforward process and information on how to do this will be supplied with the product.

Should you need any help with fitting the Flush & Save water saving device please do not hesitate to Contact Us, we’ll be happy to assist.

 
 

In need of Product Support? Call on 0121 400 0522

Send us your details and we'll get in touch within 24 hours.